NETGEAR FS728TP-100NAS

FS728TP Smart Switch FS728TP Smart Switch Software Administration Manual
Configuring QoS 5-7
v1.0, December 2007
– Disable – Disable egress shaping rate on the interface. This is the default value.
• Egress Shaping Rates CIR – Enter the Egress Shaping Committed Information Rate
(CIR) in kilobits per second. The possible field range is 0 to 62500 for FE ports and 64 to
1000000 for GE ports.
2. Select the interface.
3. Choose either Enable or Disable in the Ingress Rate Limit Status provided field in the first
row.
4. If you selected Enable in the Ingress Rate Limit Status field, enter the Ingress Rate Limit in
the provided field in the first row.
5. Choose either Enable or Disable in the Egress Shaping Rate Status provided field in the first
row.
6. If you selected Enable in the Egress Shaping Rate Status field, enter the Egress Shaping
Rates CIR in the provided field in the first row.
7. Click Apply to update the device.
Advanced
The CoS Advanced menu contains the following options:
• “CoS to Queue Mapping”
• “DSCP to Queue Mapping”
CoS to Queue Mapping
The CoS to Queue Mapping screen contains fields for mapping CoS values to traffic queues.