NETGEAR FS728TP - ProSafe 24 Port 10/100 Smart Switch - LED Designations; Port LEDs; System LEDs

FS728TP Hardware Installation Guide
Physical Description 3-20
v1.0, November 2007
Figure 3-2 illustrates the NETGEAR FS728TP Smart Switch back panel:
The back panel contains the following:
• A 100-240VAC/50-60 Hz universal input, which is a standard AC power receptacle for
accommodating the supplied power cord.
LED Designations
This section provides an explanation for the following LED types:
• Port LEDs
• System LEDs
Port LEDs
The following table describes the port LED designations.
Figure 3-2
Table 3-1. Port LEDs
Port LED Designation
1-24 Port mode select
LED
• Solid Green - Device is in Ethernet Mode
(default).
• Solid Yellow - Device is in PoE Mode.
24-10/100M Ports - One
LED/Port (Ethernet
Mode)
Link/ACT/SPD LED
(Light Pipe)
• Off - No 10/100Mbps link is established on the port.
• Solid Green - A valid 100Mbps link is established
on the port.
• Flashing Green - Packet transmission or reception
is occurring on the port at 100Mbps.
• Solid Yellow - A valid 10Mbps link is established
on the port.
• Flashing Yellow - Packet transmission or
reception is occurring on the port at 10Mbps.