Change the Language of the Local Browser Interface
By default, the language of the local browser interface is set to Auto so that the switch
can automatically detect the language. However, you can set the language to a specific
one.
To change the language of the local browser interface:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that
is off-network using an Ethernet cable.
2. Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch Using a Web
Browser on page 10.
The login window opens.
4. Enter the switch password.
The default password is password. The password is case-sensitive.
The Switch Information page displays.
5.
From the Language menu, select a language.
6.
Click the APPLY button.
A pop-up warning window opens.
7.
Click the YES button.
Your settings are saved and the language changes.
Change the Language for the Local Browser Interface by
Installing Another Firmware Version
For models GS108Ev3 and GS108PEv3, you must download and install a firmware
version in the desired language.
To change the language for the local browser interface of model GS108Ev3 or
GS108PEv3:
1. Visit netgear.com/support/download/.
2.
In the Enter a Product Name/Model Number field, start typing the model number,
and select the model from the menu that displays after you start typing.
The available firmware versions displays. The language is included in the firmware
name.
User Manual18Get Started
Gigabit Ethernet Smart Managed Plus Switches
To Next Page
Loading...
Need help?
General
