The switch returns to its factory settings. The switch reboots to load the restored
configuration.
Manage Access Control
Access control allows you to control which devices can access the switch over a web
browser for management purposes. By default, access control is disabled. By adding
one or more devices to the Access Control table, access control is enabled and only
devices in the table are allowed to access the switch over a web browser.
Note: Models GS108Ev3 and GS108PEv3 do not support access control.
For more information, see the following sections:
•
Add Devices to the Access Control Table on page 58
•
Remove Devices From the Access Control Table on page 59
Add Devices to the Access Control Table
Be sure that you use a valid subnet mask when you add a device or a range of devices
to the Access Control table.
Caution: Add the IP address and subnet mask for the device from which you are
accessing the switch to the Access Control table before you add any other devices to
the table. Otherwise, you are locked out from the local browser interface of the switch.
To add devices to the Access Control table:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that
is off-network using an Ethernet cable.
2. Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch Using a Web
Browser on page 10.
The login window opens.
4. Enter the switch password.
The default password is password. The password is case-sensitive.
User Manual58Manage and Monitor the Switch
Gigabit Ethernet Smart Managed Plus Switches
To Next Page
Loading...
Need help?
General
