NETGEAR GS308EP User Manual

Chapter 4 Use VLANS for Traffic Segmentation
VLAN overview....................................................................................33
Activate the Basic Port-Based VLAN mode and assign VLANs.....35
Manage advanced port-based VLANs.............................................36
Activate the Advanced Port-Based VLAN Mode........................36
Create an advanced port-based VLAN.......................................37
Change an advanced port-based VLAN.....................................38
Delete an advanced port-based VLAN.......................................39
Manage basic 802.1Q VLANs...........................................................40
Activate the Basic 802.1Q VLAN mode.......................................40
Create a basic 802.1Q VLAN and assign ports as members....41
Assign the port mode in a basic 802.1Q VLAN configuration..43
Change a basic 802.1Q VLAN......................................................44
Delete a basic 802.1Q VLAN........................................................45
Manage advanced 802.1Q VLANs...................................................46
Activate the advanced 802.1Q VLAN mode..............................47
Create an advanced 802.1Q VLAN.............................................48
Change an advanced 802.1Q VLAN...........................................49
Specify a port PVID for an advanced 802.1Q VLAN..................50
Set an existing advanced 802.1Q VLAN as the voice VLAN and
adjust the CoS value......................................................................52
Change the OUI table for the voice VLAN..................................53
Delete an advanced 802.1Q VLAN..............................................54
Deactivate a port-based or 802.1Q VLAN mode and delete all
VLANs...................................................................................................55
Chapter 5 Manage the Switch in Your Network
Manage NETGEAR Switch Discovery Protocol...............................58
Set up static link aggregation...........................................................58
Set up a link aggregation group..................................................59
Make a link aggregation connection...........................................60
Enable a link aggregation group.................................................60
Manage multicast...............................................................................61
Manage IGMP snooping...............................................................62
Enable a VLAN for IGMP snooping..............................................62
Manage blocking of unknown multicast addresses..................63
Manage IGMPv3 IP header validation.........................................64
Set up a static router port for IGMP snooping...........................65
Change the IP address of the switch................................................66
Reenable the DHCP client of the switch..........................................67
Chapter 6 Maintain and Monitor the Switch
Manually check for new switch firmware and update the switch..69
4
Gigabit Ethernet Smart Managed Plus Switches Series 3XXEP and 3XXEPP

NETGEAR GS308EP Specifications

General

Model	GS308EP
Category	Switch
Ports	8
PoE Ports	8
Total PoE Budget	62W
Switching Capacity	16 Gbps
MAC Address Table Size	4K
Form Factor	Desktop
Jumbo Frame Support	Yes
VLAN Support	Yes
QoS	Yes
Energy Efficient Ethernet (EEE)	Yes
PoE Standards	IEEE 802.3af/at
Switch Type	Unmanaged
Forwarding Rate	11.9 Mpps
Operating Humidity	10% to 90% non-condensing
Operating Temperature	0 to 40°C
Power Supply	External Power Adapter