Supplemental Information
66
ProSAFE Easy-Mount 8-Port Gigabit Ethernet PoE+ Web Managed Switch
Factory Default Settings
You can return the switch to its factory settings. Use the end of a paper clip or some other
similar object to press and hold the Factory Defaults button on the back panel of the switch
for at least four seconds. The switch resets and returns to the factory settings that are shown
in the following table.
Table 2. Factory default settings
Setting Value or Description
Switch name None (empty)
Switch password password
IP address 192.168.0.239
Subnet mask 255.255.255.0
DHCP mode Enabled
Port speed Auto negotiation
Flow control Disabled
Loop detection Disabled
Port LED control Link speed and activity
Power saving mode Enabled
Switch management mode Web browser GUI and ProSAFE Utility
Access control Disabled
Port mirroring Disabled
IGMP snooping • Enabled. IGMP snooping status
• Disabled. Validation of IGMPv3 IP headers
• Disabled. Blocking of unknown multicast addresses
PoE • Port Power. Enabled
• Port priority. Low
• Power mode. 802.3at
• Power limit type. User
• Power limit. 30.0W
• Detection type. IEEE 802
LAGs Disabled
Port-based VLANs Disabled
802.1Q VLANs Disabled
To Next Page
Loading...
Need help?
General
