WiFi connection using WPS
You can connect to the router’s WiFi network with Wi-Fi Protected Setup (WPS) or you
can find and select the WiFi network.
To use WPS to connect to the WiFi network:
1. Make sure that the router is receiving power (its Power LED is lit).
2.
Check the WPS instructions for your computer or WiFi device.
3. Press the Sync button on the router.
4. Within two minutes, on your WiFi-enabled computer or mobile device, press its WPS
button or follow its instructions for WPS connections.
Your computer or mobile device connects to the WiFi network.
Labels
The router label shows the login information, the WiFi network name and password,
the router’s MAC address, and the router’s serial number. The following is an example
of what the router label might look like:
Figure 4. Router label
The satellite label shows the WiFi network name and password, the satellite’s MAC
address, and the satellite’s serial number. The following is an example of what the
satellite label might look like:
User Manual19Connect to the Network and
Access the Router
Orbi WiFi System
To Next Page
Loading...
Need help?
General
Weight and Dimensions
