NETGEAR ProSafe Plus GS108E User Manual

English
2
2. For each device, insert one end of an Ethernet cable into the port in the
device and insert the other end into one of the Ethernet ports on the switch.
Modem
Firewall
GS108E
ProSafe® Plus Switch
3. Connect the power adapter cord into the back of the switch and then plug the
adapter into a power source (such as a wall socket or power strip).
4. The Power light should light up.
Power
100 Mbps
LED
Both LEDs light for
1000 Mbps connection
a
Reset
10 Mbps
LED
5. Check the LEDs to confirm that all connections are correct.
LED Activity
Power • On: Switch has power.
• Off: No power.
RJ-45 ports • Right LED on: 10 Mbps connection to a powered device.
• Left LED on: 100 Mbps connection to a powered device.
• Both LEDs on: 1000 Mbps connection to a powered
device.
• Blink: Activity on this port.

NETGEAR ProSafe Plus GS108E Specifications

General

Form Factor	Desktop
QoS	Yes
VLAN Support	Yes
Dimensions	158 x 101 x 29 mm
Switching Capacity	16 Gbps
Forwarding Rate	11.9 Mpps
MAC Address Table Size	4K
Buffer Memory	192 KB
Ports	8 x RJ45
Management	Web-based
Operating Temperature	0°C to 50°C
Humidity	90% maximum non-condensing
Jumbo Frame Support	Yes
Power Supply	External
Weight	0.48 kg