Installation
28
S3300 Smart Switch
Note: For 10GBASE-T connections, and in particular for connections over
30 meters (about 100 feet), NETGEAR recommends that you use a
Category 6a cable or a cable that is even higher rated.
Step 5: Install an SFP Transceiver Module
The following procedure describes how to install an optional SFP transceiver module into one
of the SFP ports of the smart switch.
Note: Contact your NETGEAR sales office to buy these modules. If you do
not want to install an SFP module, skip this procedure.
To install an SFP transceiver module:
1. Insert the transceiver into the SFP port.
2. Press firmly on the flange of the module to seat it securely into the connector
.
You can install up to two additional 10 Gbps or 1 Gbps modules using this procedure.
The following figure shows model S3300-52X-PoE+. However
, you install SFP transceiver
modules in the other S3300 models in the same manner.
Figure 13. Installing an SFP transceiver module
To Next Page
Loading...
