Introduction
7
S3300 Smart Switch
• Two dedicated 10G/1G SFP+ ports.
• One USB port to support firmware upgrades from a disk and backups to a storage device.
• Full NETGEAR Smart Switch functionality
.
• Full compatibility with IEEE standards:
- IEEE 802.3i (10BASE-T)
- IEEE 802.3u (100BASE-TX)
- IEEE 802.3ab (1000BASE-T)
- IEEE 802.3an (10GBASE-T)
- IEEE 802.3z (1000BASE-X)
- IEEE 802.3 Clause 49 (10GBASE-LR and 10GBASE-SR)
- IEEE802.aq (10GBASE-LRM)
- IEEE802.3ae (10GBASE Ethernet)
- IEEE802.3az (Energy Ef
ficient Ethernet)
- IEEE 802.3x (Full-duplex flow control)
- IEEE 802.1at (PoE+)
• AutoSensing and autonegotiating capabilities for all ports.
• Auto Uplink technology is supported on all ports.
• Automatic address learning function to build the packet-forwarding information table.
The
table contains up to 16K Media
Access Control (MAC) addresses.
• Store-and-forward transmission to remove bad packets from the network.
• Full-duplex IEEE 802.3x pause frame flow control.
• Active flow control to minimize packet loss and frame drops.
• Half-duplex backpressure control.
• Per-port status LEDs and system status LEDs.
• Internal open frame power supply
.
• Standard NETGEAR chassis (1U high).
• NETGEAR green power-saving features:
- Energy ef
ficiency mode that fully conforms to the IEEE802.3az standard
- Per-port automatic change to a lower power mode when the port link is down
• Support for Power over Ethernet (PoE+) on models S3300-52X-PoE+ and
S3300-28X-PoE+.
• Support for an RPS4000 external power supply to provide a larger power budget for
model S3300-52X-PoE+ or model S3300-28X-PoE+.
To Next Page
Loading...
Need help?
General
