To allow VPN clients to use your home Internet service:
1. Launch a web browser from a computer or mobile device device that is connected to the network.
2. Enter http://www.routerlogin.net.
A login window opens.
3. Enter the router user name and password.
The user name is admin.The default password is password.The user name and password are
case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > VPN Service.
The VPN page displays.
5. Make sure that the Enable VPN Service radio button is selected.
For information about configuring the TUN and TAP mode options, see Specify VPN Service in the
Router on page 191.
6. Scroll down to the Clients will use this VPN connection to access section, and select the All sites on
the Internet & Home Network radio button.
When you access the Internet with the VPN connection, instead of using a local Internet service, you
use the Internet service from your home network.
By default, the Auto radio button is selected, which lets the router use an automatic
detection system that enables VPN access only for necessary services and sites and
might not include full Internet access.
Note
7. Click the Apply button.
Your settings are saved.
Block VPN Client Internet Access in the Router
By default, the router is set up to allow VPN connections only to your home network, not to the Internet
service for your home network. If you changed this setting to allow Internet access, you can change it back.
To allow VPN clients to access only your home network:
1. Launch a web browser from a computer or mobile device device that is connected to the network.
2. Enter http://www.routerlogin.net.
A login window opens.
3. Enter the router user name and password.
The user name is admin.The default password is password.The user name and password are
case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > VPN Service.
Use VPN to Access Your Network
199
Nighthawk AC1900 Smart WiFi Router Model R6900v2
To Next Page
Loading...
Need help?
General
