NETGEAR ReadyNAS User Guide
1-32 Configuring Your ReadyNAS
v1.0, October 2007
device number; for example, USB_HDD_2. If the device contains multiple partitions, the
partitions are listed beneath the main device entry.
Partitions on the storage devices must be one of the following file system formats:
•FAT32
• NTFS
•Ext2
•Ext3
To the right of the access icons are command options for the device. The following commands are
available:
Figure 1-35
Disconnect This option prepares the USB partition for disconnection by correctly unmounting the file
system. In most cases, you can safely disconnect the device without first unmounting;
however, the Disconnect command ensures that any data still in the write cache is
written out to the disks and that the file system is properly closed. The Disconnect option
unmounts all partitions on the device. Once disconnected, physically remove and re-
connect to the ReadyNAS to regain access the USB device,.
Locate In cases where you attach multiple storage devices and wish to determine which device
corresponds to the device listing, the Locate command causes the device LED to blink, if
present.
To Next Page
Loading...
