NETGEAR SRK60B04 User Manual

Orbi Pro WiFi system LEDs
The following table describes the LED behavior for an Orbi Pro router (model SRR60)
and Orbi Pro satellite (model SRS60) that are purchased together and come in the same
package.
Table 1. Orbi ProWiFi System router and satellite LED descriptions
LED BehaviorLED
The Power LED is located above the Power On/Off button on the rear panel.
•
Solid green. Power is on.
•
Solid amber. The router or satellite is booting.
•
Blinking amber. The router or satellite is resetting to factory default settings.
•
Blinking red. The firmware is corrupted.
•
Off. Power is not supplied.
Power LED
The ring LED is located on the top.
•
Pulsing white. The router is booting or someone pressed the Sync button.
•
Off. The router finished booting and is working normally.
•
Solid white. The router is resetting to factory default settings.
•
Solid magenta. The router cannot connect to the Internet. See You cannot access the
Internet on page 165.
Router ring LED
This satellite is included when you buy an Orbi router. The ring LED is located on the
top.
•
Pulsing white. The satellite is booting.
•
Blue for three minutes. The connection between the satellite and the router is good.
•
Amber for three minutes. The connection between the satellite and the router is fair.
•
Magenta. The satellite failed to sync to the router. See The router and satellite do not
sync on page 163.
•
Off. The satellite synced to the router and is working normally.
Satellite ring
LED
Add-on Orbi Pro satellite LEDs
The following table describes the LED behavior for an add-on Orbi Pro satellite (model
SRS60) that was purchased separately from the Orbi Pro kit.
User Manual12Overview
Orbi Pro Router Model SRR60 and Orbi Pro Satellite Model SRS60

NETGEAR SRK60B04 Specifications

General

Brand	NETGEAR
Model	SRK60B04
Category	Network Router
Language	English