Need help?Do you have a question about the NETGEAR S8000 and is the answer not in the manual?
General| Category | Network Switch |
|---|---|
| Form Factor | Desktop |
| Managed | Yes |
| Power over Ethernet (PoE) | No |
| Jumbo Frame Support | Yes |
| Quality of Service (QoS) | Yes |
| VLAN Support | Yes |
| Fanless Design | Yes |
| Ports | 8 |
Details on installation guides and data sheets available online.
Lists the items included in the switch package, such as the adapter.
Explains the status indicators on the switch's top and back panels.
Describes the components and ports located on the switch's back panel.
Provides information about the label on the switch's bottom panel.
Outlines crucial safety guidelines for using the switch and preventing damage.
Step-by-step guide for connecting devices and powering on the network switch.
Details various ways to find and connect to the switch for management.
Instructions on configuring a static IP address for consistent switch access.
Guide to changing the default login password for enhanced security.
How to select predefined modes like Gaming or Media Streaming for optimal performance.
Configure QoS settings and port rate limits manually for fine-tuned traffic management.
Customize settings for each port, including priority, rate limits, and flow control.
Introduction to Virtual LANs (VLANs) and their role in network segmentation.
Steps to enable basic port-based VLANs and assign ports to VLANs.
Configuration options for advanced port-based VLANs, including multiple VLANs per port.
Guides for setting up and managing basic 802.1Q VLANs for network traffic control.
Detailed configuration for advanced 802.1Q VLANs, including tagging and PVIDs.
Configure UPnP, Bonjour, and NSDP to facilitate switch discovery on the network.
Combine multiple Ethernet ports into a single logical link for increased bandwidth or fault tolerance.
Instructions for assigning a static IP address to the switch for easier management.
Steps to restore the switch's ability to obtain an IP address automatically via DHCP.
Procedure to check for, download, and install the latest firmware for the switch.
How to back up and restore the switch's configuration settings.
Resetting the switch to its original factory configuration and settings.
Define which IP addresses are allowed to access the switch's management interface.
Utilize the cable diagnostic feature to check network cable health and fault location.
Remotely restart the switch using its web-based management interface.
Information on how the switch detects and warns about network looping conditions.
Steps to fix issues where the switch's subnet conflicts with the network's subnet.
Methods for discovering and accessing the switch from any connected computer.
To Next Page