NETGEAR S8000

Delete a Custom Preset Mode
You can delete a custom preset mode that you no longer need.
To delete a custom preset mode:
1.
Open a web browser from a computer that is connected to the same network as the
switch or to the switch directly through an Ethernet cable.
2. Enter the IP address that is assigned to the switch.
The login page displays.
3. Enter the switch password.
The default password is password. The password is case-sensitive.
The HOME page displays.
4.
Select PRESET MODES.
The PRESET MODES page displays. The LOAD tab is automatically selected.
5. Select the custom preset mode.
The PREVIEW page displays.
6.
Click the DELETE button.
Your settings are saved. The custom preset mode is removed from the PRESET
MODES pages.
Manually Set the Quality of Service Mode
and Port Rate Limits
Instead of using preset performance modes, you can manually set the Quality of Service
(QoS) modes to manage traffic:
•
Port-based QoS mode. Lets you set the priority (low, medium, high, or critical) for
individual port numbers and lets you set rate limits for incoming and outgoing traffic
for individual ports. If broadcast filtering is enabled, you can also set the storm control
rate for incoming traffic for individual ports.
•
802.1P/DSCP QoS mode. Applies pass-through prioritization that is based on
tagged packets and lets you set rate limits for incoming and outgoing traffic for
individual ports. If broadcast filtering is enabled, you can also set the storm control
rate for incoming traffic for individual ports.
User Manual34Optimize the Switch
Performance
Nighthawk S8000 Gaming & Streaming Advanced 8-Port Gigabit Ethernet Switch (GS808E)