NETGEAR S8000

Table 3. Factory default settings (Continued)
Default SettingFeature
DisabledIGMPv3 IP header
validation
NoneStatic router port for IGMP
snooping
Ports and LEDs
AutonegotiationPort link speed
EnabledPort LEDs
EnabledPower LED
Other features
No LAGs configuredLink aggregation
DisabledAccess control
DisabledDoS prevention
DisabledPower saving mode
Enabled (nonconfigurable)Loop detection
Enabled (nonconfigurable)Jumbo frames
Technical Specifications
The following table shows the technical specifications of the switch.
Table 4. Technical specifications
DescriptionFeature
IEEE 802.3 Ethernet
IEEE 802.3x Full-Duplex Flow Control
IEEE 802.3u 100BASE-TX
IEEE 802.1p Class of Service
IEEE 802.3ab 1000BASE-T
IEEE 802.3az Energy Efficient Ethernet (EEE)
IEEE 802.1p Class of Service
IEEE 802.1Q VLAN tagging
IEEE standards
RJ-45, supporting 10BASE-T, 100BASE-TX, or 1000BASE-TNetwork connectors
User Manual102Factory Default Settings and
Technical Specifications
Nighthawk S8000 Gaming & Streaming Advanced 8-Port Gigabit Ethernet Switch (GS808E)