Use the Local Browser Interface to Reset the Switch
Caution: This process erases all settings that you configured on the switch.
To reset the switch to factory default settings using the local browser interface:
1.
Open a web browser from a computer that is connected to the same network as the
switch or to the switch directly through an Ethernet cable.
2. Enter the IP address that is assigned to the switch.
The login page displays.
3. Enter the switch password.
The default password is password. The password is case-sensitive.
The HOME page displays.
4.
From the menu at the top of the page, select SETTINGS.
The PRESET MODES page displays.
5.
From the menu on the left, select FACTORY DEFAULT.
The FACTORY DEFAULT page displays.
6.
Click the RESTORE DEFAULT SETTINGS button.
A warning pop-up window opens.
7.
Click the CONTINUE button.
The switch is reset to factory default settings and reboots.
Warning: Do not interrupt the network connection or power to the switch during
the reset process. Do not disconnect any Ethernet cables or power off the switch
until the reset process and switch reboot are complete.
User Manual87Maintain and Monitor the Switch
Nighthawk S8000 Gaming & Streaming Advanced 8-Port Gigabit Ethernet Switch (GS808E)
To Next Page
Loading...
