4.
If the satellite ring LED is magenta, move the satellite closer to the router and then
sync the satellite to the router:
a.
Press the Sync button on the back of the router.
b.
Within two minutes, press the Sync button on the back of the satellite.
The satellite attempts to sync to the Orbi router. The satellite ring LED lights blue,
amber, or magenta as described in Step 3 of this procedure and then turns off.
Sync an add-on Orbi Pro satellite
If you already set up an Orbi Pro router and satellite and you are adding an optional
add-on Orbi Pro satellite (sold separately), follow these steps.
Note: When you purchase an Orbi Pro satellite separately from the Orbi Pro router,
the satellite has a different WiFi network name and password. However, after syncing
the add-on satellite with the router, the satellite uses the same WiFi network name and
password as the router.
To sync your add-on Orbi Pro satellite:
1. Place your satellite.
For more information, see Place your satellite on page 18.
2. Connect the satellite to a power source.
3.
If the Power LED on the back of the satellite does not light, press the Power On/Off
button.
4.
Wait about two minutes for the satellite ring LED to light solid white.
5.
Press the Sync button on the back of the satellite and within two minutes, press the
Sync button on the back of your Orbi router.
The satellite ring LED pulses white, then lights one of the following colors for about
three minutes, and then turns off:
•
Blue. The Orbi router and satellite successfully synced, and the connection
between the router and satellite is good.
•
Amber. The Orbi router and satellite successfully synced, and the connection
between the router and satellite is fair. Consider moving the Orbi satellite closer
to the Orbi router.
•
Magenta. The Orbi router and satellite failed to sync. Move the satellite closer
to the router and try again.
User Manual19Overview
Orbi Pro Router Model SRR60 and Orbi Pro Satellite Model SRS60
To Next Page
Loading...
Need help?
General
