User Manual for the NETGEAR 108 Mbps Wireless PC Card 32-bit CardBus WG511T
Introduction 2-5
Connect to the
Internet over my
wireless
network.
1. Activate my
wireless link
and verify my
network
connection.
2. Open an
Internet
browser such
as Internet
Explorer or
Netscape
Navigator.
1. An active Internet connection
like those from cable or DSL
service providers.
2. A wireless network connected
to the cable or DSL Internet
service through a cable/DSL
router as illustrated in
“Connecting to an Access
Point in Infrastructure Mode”
on page 4-2.
3. TCP/IP Internet networking
software installed and
configured on my notebook PC
according to the requirements
of the Internet service provider.
4. A browser like Internet
Explorer or Netscape
Navigator.
To configure your WG511T in
Infrastructure Mode, see “Basic
Installation Instructions” on
page 3-4, and locate the section
for your version of Windows.
For assistance with configuring
the TCP/IP Internet software on
a PC, see “Preparing Your
Computers for TCP/IP
Networking” on page C-1 or refer
to the PC Networking Tutorial on
the NETGEAR 108 Mbps
Wireless PC Card WG511T
Resource CD (SW-10036-01)
and the Help information
provided in the Windows system
you are using.
.
Table 2-1. A Road Map for How to Get There From Here ...
If I Want To ... ? What Do I Do? What’s Needed? How Do I?
To Next Page
Loading...
