User Manual for the NETGEAR 108 Mbps Wireless PC Card 32-bit CardBus WG511T
3-4 Basic Setup
Basic Installation Instructions
Use the procedure below that corresponds to the version of Windows you are using.
For Windows XP Users Installing a WG511T
Install the WG511T driver and
configuration utility software.
a. Power on your notebook, let the
operating system boot up completely,
and log in as needed.
b. Insert the Resource CD for the WG511T
into your CD-ROM drive. The CD main
page shown at the right will load.
c. Click the “Install Driver & Utility” link.
d. Follow the InstallShield Wizard steps,
and click Finish when done to restart
your computer.
WG511T Resource CD
InstallShield Wizard
Note: If a Windows XP Certification warning
appears, click Continue Anyway to proceed.
To Next Page
Loading...
