Reference Manual for the 108 Mbps Wireless Firewall Router WGT624 v3
Content Filtering 4-5
v3.0, December 2005
To select Parental Controls Mode, choose one of the following:
• Select the Use General Controls radio button to create a blanket setting that allows access to
Web sites that contain content that are appropriate for viewing by all users accessing the
Internet through the router.
• Select the Enforce Per-User Controls radio button to allow access to certain categories of
Web sites on a per-user basis.
• Parental Controls Bypassing Password (General mode): Enter a password into the Parental
Controls Bypassing Password box. Then enter the password a second time in the Confirm
Password box to confirm that both passwords match. With this password, users can view Web
sites containing content that would normally be blocked by the Parental Controls setting
• Parental Controls User Account (Per-User only): The User List lists the names of the users
currently accessing the Internet, the level of access they have (as determined by Parental
Controls Setting), and whether they are enabled in the system or not.
a. Click Add User to give permission to a user to access the internet through the router.
b. Under the Account Information section, enter a name for the person wanting access to the
Internet.
c. Then enter a password that the user will be required to use when attempting to access the
internet.
d. Enter the password again in the Confirm Password textbox.
e. Finally, next to the Status section, choose whether to enable or disable this person’s
account.
Note: When in Per-User mode, everyone accessing the Internet through the router is
required to log in.
Note: Users on the user list cannot log in or access the Internet if “Enforce Per-Use
Controls” is not enabled.
Note: When in Per-User mode, everyone accessing the Internet through the
router will have to log in.
To Next Page
Loading...
Need help?
General
