Reference Manual for the 108 Mbps Wireless Firewall Router WGT624 v3
6-4 Maintenance
v3.0, December 2005
Viewing a List of Attached Devices
The Attached Devices menu contains a table of all IP devices that the router has discovered on the
local network. From the main menu of the browser interface, under the Maintenance heading,
select Attached Devices to view the table shown below:
For each device, the table shows the IP address, NetBIOS Host Name (if available), and Ethernet
MAC address.
Upgrading the Router Software
The router software of the WGT624 v3 wireless router is stored in FLASH memory, and can be
upgraded as new software is released by NETGEAR.
Figure 6-2
Note: Rebooting the router empties the table data until the router rediscovers the devices.
To force the router to look for attached devices, click Refresh.
Note: The web browser used to upload new firmware into the WGT624 v3 wireless router
must support HTTP uploads. Use Microsoft Internet Explorer or Netscape
Navigator 4.0 or above. Do not interrupt the upgrade process once it has started.
Note: Be sure to check the NETGEAR web site for documentation updates which are
available at http://www.netgear.com/docs.
To Next Page
Loading...
Need help?
General
