Reference Manual for the 108 Mbps Wireless Firewall Router WGT624 v3
Maintenance 6-5
v3.0, December 2005
From the Maintenance section of the main menu, select the Router Upgrade heading to display
the menu shown below.
To check for new firmware, click Check.If the WGT624 v3 finds new firmware is available,
follow the on-screen prompts to download in install the new firmware.
To upload firmware from your hard drive:
1. In the Router Upgrade menu, click Browse and browse to the location of the binary (.chk)
upgrade file.
2. Click Upload.
Figure 6-3
Note: When uploading software to the WGT624 v3 wireless router, it is important not to
interrupt the web browser by closing the window, clicking a link, or loading a new
page. If the browser is interrupted, it may corrupt the software. When the upload is
complete, your router will automatically restart. The upgrade process will typically
take about one minute.
Note: In some cases, you may need to reset to factory default and reconfigure the router
after upgrading.
To Next Page
Loading...
Need help?
General
