Reference Manual for the 108 Mbps Wireless Firewall Router WGT624 v3
Wireless Configuration 5-5
v3.0, December 2005
• Region. This field identifies the region where the WGT624 v3 can be used. It may not be legal
to operate the wireless features of the wireless router in a region other than one of those
identified in this field.
• Channel. This field determines which operating frequency will be used. It should not be
necessary to change the wireless channel unless you notice interference problems with another
nearby access point. For a link to more information on the wireless channel frequencies, see
“Wireless Communications” in Appendix B.
• Mode. This field determines which data communications protocol will be used. You can select
“Auto 108 Mbps”, “g only”, or “g and b”. The “g only” option dedicates the WGT624 v3 to
communicating with the higher bandwidth 802.11g wireless devices exclusively. The “g and
b” mode provides backward compatibility with the slower 802.11b wireless devices while still
enabling 802.11g communications. The “Auto 108 Mbps” mode works with 802.11g, 802.11b,
and NETGEAR 108 Mbps devices.
• Security Options. These options are the wireless security features you can enable. The table
that follows identifies the various basic wireless security options. For a link to a full
explanation of these standards, see “Wireless Communications” in Appendix B.
To Next Page
Loading...
Need help?
General
