NETGEAR WN3100RP - Return the Extender to Its Factory Default Settings

Maintain and Monitor the Extender
37
N300 WiFi Range Extender
Return the Extender to Its Factory Default Settings
Under some circumstances (for example, if you lose track of the changes that you made to
the extender settings), you might want to erase the configuration and reset the extender to
factory default settings.
To reset the extender to factory default settings, you can either use the Factory Reset button
on the side panel or log in to the extender and reset it.
For a list of factory default settings, see Factory Default Settings on page 48.
Use the Factory Reset Button
CAUTION:
This process erases any settings that you configured in the extender.
 To use the Factory Reset button to return the extender to factory default settings:
1. Insert a straightened paper clip into the hole of the Factory Reset button and hold it for
about seven seconds.
Reset button
2. Release the button.
CAUTION:
Do not try to go online, turn off the extender, shut down the computer, or
do anything else to the extender until it finishes restarting!
The extender resets and restarts. This process takes about one minute.