Advanced Settings
92
N600 Wireless Dual Band Gigabit Router Premium Edition WNDR3800
enable the wireless base station in either radio band and use the other radio band as a
wireless router or wireless base station, dual band concurrent mode is not affected.
For you to set up a wireless network with WDS, he following conditions have to be met for
both access points:
• Both access points have to use the same SSID, wireless channel, and encryption mode.
• Both access points have to be on the same LAN IP subnet. That is, all the access point
LAN IP addresses are in the same network.
• All LAN devices (wired and wireless computers) have to be configured to operate in the
same LAN network address range as the access points.
Wireless Repeating Function
Select Advanced > Advanced Setup > Wireless Repeating Function to view or change
wireless repeater settings for the router.
The set of fields is the same for the 2.4 GHz or 5 GHz wireless network.
• Enable Wireless Repeating Function (2.4 GHz/5 GHz). Select the check box for the
2.4 GHz or 5 GHz network to use the wireless repeating function.
• Wireless MAC of this router. This field displays the MAC address for your router for your
reference. You will need to enter this MAC address in the corresponding Wireless
Repeating Function screen of the other access point you are using.
• Wireless Repeater. If your router is the repeater, select this check box.
Repeater IP Address. If your router is the repeater, enter the IP address of the other
access point.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
