NETGEAR XS728T User Manual

5
1
1. Introduction
This hardware installation guide is for the following NETGEAR
®
ProSAFE
®
Smart Managed
Switches:
• Model XS728T 28-Port 10-Gigabit Smart Managed Switch
• Model XS748T 48-Port 10-Gigabit Smart Managed Switch
These models provide twenty-four or forty-four 1000/10GBASE-T RJ-45 copper ports and four
dedicated enhanced small form-factor pluggable (SFP+) GBIC slots that can accept SFP+ 1G
and 10G copper and fiber optical modules.
In this hardware installation guide, except where indicated otherwise, these models are referred
to as the switch. This hardware installation guide complements the installation guide that came
with the switch.
The chapter includes the following sections:
• Overview
• Features
• Safety Instructions and Warnings
Note: For more information about the topics that are covered in this manual,
visit the support website at www.support.netgear.com.
Note: For detailed technical specifications and information about supported
features, see the datasheet:
For model XS728T, visit www.netgear.com/XS728T.
For model XS748T, visit www.netgear.com/XS748T.
Note: For software and configuration documentation, see the links on the
resource CD in the product package or visit downloadcenter.netgear.com.

NETGEAR XS728T Specifications

General

Model	XS728T
Ports	28
10GBase-T Ports	24
SFP+ Ports	4
Switching Capacity	560 Gbps
Form Factor	Rack-mountable
Layer	Layer 3
Management	Yes
Weight	18.5 lbs
Total Number of Network Ports	28
Uplink Port	Yes
Ethernet Technology	10 Gigabit Ethernet
Number of Total Expansion Slots	4
Number of SFP+ Slots	4
Manageable	Yes
Width	440 mm
Forwarding Rate	417 Mpps
Power Supply	Internal
MAC Address Table Size	32K
Jumbo Frame Support	Yes
Humidity	10% to 90% non-condensing
Product Type	Switch
Media Type Supported	Twisted Pair, Optical Fiber
Layer Supported	Layer 3
Power Source	AC
Height	43.2 mm
Operating Temperature	0°C to 50°C
Storage Temperature	-20°C to 70°C
Latency (10G)	1.5 μs