Netio 230C - Page 27

Control and configuration
22
<send_email: enable|disable> - on/off of e-mail message transmission at the
moment of unavailability of the monitored device or upon overrun of the value
max_retry
Example: The command port wd 2 enable 192.168.10.101 10 30 1 3 enable enable
permits the watchdog function on output 2. The device at the address 192.168.10.101 will be
monitored. The maximum response time of the monitored device shall be 10 seconds. The ping
commands shall be sent at one-second intervals. If the monitored device does not respond within
10 seconds, output 2 is switched off for 30 seconds. If the device shall not respond to ping
commands after set switch-off three times in a row, the port is switched off for the fourth time and
remains off. A warning e-mail message shall be sent to you each time the port is switched off.
system eth
Lists the network interface settings in the format: <dhcp | manual> <ip_address> <mask>
<gateway>
system eth <dhcp | manual> [<ip_address> <mask> <gateway>]
Sets the network interface - IP address, network mask and gateway are set only if the manual
parameter is selected. For the changes to take effect, it is necessary to either restart the system
with the command reboot, or switch the NETIO off/on.
Example: The system command eth manual 192.168.10.150 255.255.255.0 192.168.10.1
sets the network address 192.168.10.150, network mask 255.255.255.0 and default gateway
to 192.168.10.1.
email server <ip | domain_server_address>
Sets the IP address, or domain name of the SMTP server.
system discover <enable|disable>
Enables/disables network parameter settings from the discover utility.
system discover
Lists whether the system discover selection is enabled, or disabled.
system swdelay <delay>
Sets the delay time between the connection of two ports. The value is given in decimal seconds.
system swdelay
Lists the delay time between the connection of two ports.
system dns <ip>
Sets the IP address of the DNS server. For the changes to take effect, it is necessary either to
restart the system using the reboot command or switch the NETIO off/on.
system dns
Lists the set address of the DNS server.