19
Write the IP address assigned to the Adapter. To change the IP address, use the format
aaa.bbb.ccc.ddd, where aaa, bbb, ccc and ddd are numbers from 0 to 255. If you write a
number outside this interval, the software reconverts the number to a value from the interval 0
to 255. If you do not know the IP address, call your system administrator.
Mask IP address (network mask - Netmask)
Write a network mask for the adapter. To change the network mask (Netmask)
address, use the format aaa.bbb.ccc.ddd, where aaa, bbb, ccc and ddd are numbers from the
interval 0 to 255. If you write a number outside the interval, the software reconverts the
number to a value from the interval 0 to 255. If your local network is divided into sub-
networks, make sure to have the value set (for example, 255.255.0.0).
Router IP address (gateway)
Define the gateway address. The gateway is a predefined termination for all packets not
addressed to the local network. Use the format aaa.bbb.ccc.ddd, where aaa, bbb, ccc and ddd
are numbers from the interval 0 to 255. If you write a number outside the interval 0 to 255, the
software reconverts the number to a value from the interval. If the gateway is not used, enter
zero value (0).
SysContact, SysName, SysLocation
These 3 strings define the names for the Contact and name of the administrator and the
location. Are used only in the NMS program.
UDP port
The UDP port can be changed if another device on the network use the same.
To Next Page
Loading...
