25
It is used to reset the NetMan.
Upgrade firmware
With this command it is possible make the firmware upgrade in two different ways:
if you are connected via serial port it will be possible make the upgrade using the Xmodem
protocol,
if you are connected via Telnet the firmware will be upgraded making a download from a
TFTP server specified at the point A of this menu.
NetMan will find the file named netman10x.bin on the server, if this file exists the firmware
upgrade will be done with the new firmware.
It is also possible make the upgrade from a computer with the TFTP server executing the
command UPDATE included on the floppy disk in bundle.
The command has the follow sintax:
update <netman address> <firmware file.bin> <TFTP server>
At the end of the upgrade the NetMan will reboot automatically after about 10 seconds.
Set TFTP server
It is used to configure the server TFTP from it will be possible download the new firmware.
This address has full access to the NetMan like the host addreses on the access list.
II. 3. 10. Exit
To exit from the configuration program press q. For reconfiguration, insert again the password
to start the configuration program.
To Next Page
Loading...
