To keep your revised settings without saving them
to a profile, touch the back arrow icon to the left of
the Settings screen header. Your new settings are
applied, and an asterisk * is added to the profile
name to indicate unsaved changes.
See Profiles and Jobs for more on profiles.
PoE
Enable PoE: Slide the toggle switch right to enable
the PoE test portion of AutoTest, and slide left to
disable it.
Enable TruePower™: Slide the toggle switch right
to enable the TruePower feature. TruePower
validates that the Switch (PSE) and cabling can
provide the requested power under load.
Class: Touch the down caret to the right of the
field to select a PoE class setting to match your
switch's (or PoE injector's) available class. The
LinkRunner G2 supports Cisco's UPOE, which can
provide up to 51W. (Note that your switch may
advertise a wattage higher than 51W, but because
of loss over the cable, the LR G2 does not receive
the total wattage provided by the switch.)
36
LinkRunner G2 Application Settings
To Next Page
Loading...
