Connect
Speed/Duplex: Select the speed and duplex
option that you want to test your network against.
The default is Auto negotiation.
Security
802.1X Authentication: Slide the toggle switch
right to enable 802.1X authentication.
EAP Type: This field appears if 802.1X
authentication is enabled. Touch the down arrow
to choose the correct type. Additional security
fields, such as Username and Password, display as
required.
IP
IPv6: Slide the toggle switch right to enable IPv6.
IP Configuration: Touch the down caret to
switch between DHCP and Static IP configuration.
If you choose static, the IP Address, Subnet Mask,
and other IP fields display. Touch each field to
open a pop-up number pad and enter the
addresses as needed. Touch OK to save them.
Proxy: Slide the toggle switch right to enable
Proxy settings. When proxy is enabled, the
37
LinkRunner G2 Application Settings
To Next Page
Loading...
