(4)
AT+MODE=2
AT+MODE=3
AT+MODE=1
Basic Mode (HID) (default)
• NO software installation needed
• Connects to most devices
• Scanner interacts with host device like a keyboard
Important Notes:
If you want to shift from HID to SPP or BLE just scan the Corresponding command
barcode. If you want to shift from SPP or BLE to HID mode,
irst ignore (or delete) "Netum
Bluetooth"→ turn off bluetooth→ scan command barcode of HID→ Open the bluetooth →
re-pair it.
Application Mode (Apple Specific Serial Profile)
• For Android or Windows
• Software installation is required
• If you have an application that supports this is the mode recommended
Applicatin Mode (Serial Port Profile)
• For iOS Devices
• If you have an iOS application that supports our Scanners this is the mode to use
To Next Page
Loading...
