Working Mode
If you are heading for a working area which lies outside the signal range, you may activate the offline mode of the
scanner, following the steps described below. Under this enhanced offline mode, all scanned data will be stored directly
into the buffer memory of the device. Furthermore, the data entries will be permanently saved in the buffer memory
prior to the manual upload into the working station, so that you may upload them time and again to your liking.
1). By scanning the following barcode, the offline mode will be activated
2). By scanning the following barcode, all data in the buffer memory will be deleted
3).By scanning the following barcode, all data entries in the buffer memory can be manually uploaded after reconnecting
to the working station (only in offline mode).
4). By scanning the following barcode, the gross quantity of the uploaded data entries will be summarised (only in offline
mode).
5). By scanning the following barcode, the device leaves the offline mode, normal mode will be
reinitialised. (By default)
To Next Page
Loading...
Need help?
General
