Scanner does not read
“shiny” bar codes.
Reflected light
distorts the
scan beam.
Scan at a slight angle or pitch to the bar
code (see “Operating the Scanner”
earlier in this guide).
Further operating the scanner
To display the total scan number, to
clear stored data, to upload data.
Scan the related bar codes in “bar code
settings” earlier inn this guide.
To identify codes by displaying the
related reader IDs in a situation that
a base communicates with many
readers simultaneously.
To construct a “many to one” network.
1) scan the code “enter setting” on the top of page
9.
2) scan the code “display transmitter ID” on page
9, the reader will emit beeps.
3) put the reader close to the base and unplug the
base for a few seconds and then plug back. The
flashing light and the beeper will stop.
4) scan the last code on page 9 “save & exit”.
There will be an ID number of this reader “10”
displayed before this reader’s every scanned
code. (Defaulted: 10)
To change the ID to other number, like “200”
(range: 1-254)
1) scan the code “enter setting” on the top of page
8.
2) scan the code “set transmitter ID” on page 8.
3) scan the numbers codes on page 11, “2”, “0”,
“0” and end with “#”.
4) scan the code on page 8 “save & exit”.
To configure different working
channels for scanner sets to
communicate simultaneously
in a network and avoid data
interference on hosts. E.g.:
channel=6. (Defaulted= 10)
Make sure that the base is connected to the host
with antenna.
Set transmitter channel.
1) scan the code “enter setting” on page 8.
2) scan the code “set transmitter channel” on page
8.
3) scan the number code “6” on page 11 and end
with “#”.
To Next Page
Loading...
Need help?
General
