Netum NT-1203 Bluetooth Connection Guide

Model NT-1203 With SPP Mode
Get Started: This is 1D and 2D bluetooth scanner. Follow below "bluetooth connection"
instruction to pair with your device and then setup the keyboard language (if you US
keyboard, you can skip this step). After that the scanner can start to read and upload
the barcodes. If you want to do other configurations please refer to programming
barcodes.
Low voltage Alarm: Scanner will make 3x beeps (even you just trigger the button and
do not scan any barcodes) to remind you that it's under low voltage. Please connect
the base with your device via USB cable ,then put the scanner on the base to charge
power for it.
Barcode Programming
Netum barcode scanners are factory programmed for the most common terminal and
communications settings. If you need to change these settings, programming is
accomplished by scanning the bar codes in this guide. An asterisk (*) next to an option
indicates the default setting.
Important Note: There will not have a beep sound for some of configuration but as
long as light turns off a few seconds before you release the trigger button that
indicates the scanner has read the codes successfully.

Netum NT-1203 Specifications

General

Weight	150g
Connectivity	Bluetooth
Supported Symbologies	Code 39, Code 93, Code 128, Codabar, MSI, EAN-8, EAN-13, UPC-A
Operating System Compatibility	Windows, Android, iOS
Supported Barcodes	1D
Light Source	650nm
Operating Voltage	DC 5V
Dimensions	160mm