Installing the scanner
Connecting the base with USB cable to a computer
1. Connect the base with the cable into the computer’s connector.
2. Windows will automatically install the driver. (If not, you need to install the driver
by manual on the host to communicate with the scanner.)
3. When connection is finished, windows will indicate “The hardware has been
installed and can be used” and the scanner light will be on.
4. If connection fails, unplug the base and repeat the above steps.
Installing the antenna
1. Connect the antenna vertically to the antenna interface on the base.
2. Hold the antenna and tighten it by rotating the nut head clockwise until secure.
Notes: To remove the antenna, please operate by inverse steps.
Starting wireless scanning
Scan the code “start wireless scanning” on the association cards or page 11 of the
guide book.
Understanding the features
Audio and visual indications during data transmission:
Flash 3 times (changed into
Storage Mode)
Storage function:
When communication fails (out of base range or signal interference), the reader will
store the scanned barcode information automatically. You can also select storage
mode by manual. 4M inner memory, can store 40-100 thousand barcodes information.
Low power alarm:
In case of instant auto-shutdown after startup, please charge the battery as the power
is low.
Charging:
Please fully charge the battery for first time use. Shut down the scanner before
charging. When the reader/terminal is on charge, both the blue and the red lights on
the base will be on. When charging is finished, only the red one will be on.
To Next Page
Loading...
Need help?
General
