SECTION 2 – CONTROLS, INSTRUMENTS AND OPERATION
2–122
Calibration of the Ground speed hydrostatic
IMPORTANT: Do the calibration of the
”Multifunction handle” before calibrating the
“Ground speed hydrostatic”.
To calibrate the ground speed hydrostatic, proceed
as follows:
1. Select the “Ground speed hydrostatic” calibration
window.
Message: “Shift transmission to first gear”.
Message: “Disengage parking brake”.
Message: “Throttle engine to high idle”.
Message: “Then press ENTER”.
2. Place the multifunction handle in neutral position.
3. Select the first gear and set the parking brake off.
4. Set the engine rpm to maximum (2100 rpm).
5. Press “enter” to continue or “esc” to exit the
calibration window.
210
Message: “Forward calibration started”.
Message: “Slowly move handle forward out of the
locked neutral position”.
6. Move the multifunction handle from the locked
neutral position slowly forward.
7. Waiting on target.
211
Message: “Stop moving handle”, “determining”,
“Threshold...”.
8. Stop moving handle and wait until the next
message.
212
To Next Page
Loading...
Need help?
General
