ChipSHOUTER Users Manual: High Voltage Warnings
10
voltages, this may generate U.V. light and other
dangerous radiation. ChipSHOUTER will also be se-
verely damaged during the discharge process, as
the spark-gap discharge exceeds allowed dv/dt
ratings of the driver circuit.
• The insulation on the injection probes must be
unbroken for your protection. Carefully inspect
the probes for damage to the insulation, and de-
stroy (to prevent accidental reuse) and discard
any damaged probes.
• DO NOT position the injection probes in such a
manner they will scrape conductive areas of the
device under test.
• The SMA connector shell is NOT connected to the
enclosure (chassis). Do not short the SMA con-
nector shell to the enclosure or ground, as
otherwise high voltages and currents could pass
through this connection.
• Do not connect anything besides a EMFI injection
probe or included accessory to the ChipSHOUTER
output.
To Next Page
Loading...