ChipSHOUTER Users Manual: External Connections
26
DC Power Jack
The ChipSHOUTER uses a 4.75mm x 1.7mm center-positive barrel
connector (EIAJ-03), with a 19VDC ± 10% input voltage. Dur-
ing standby (not armed) the ChipSHOUTER draws approximately
20mA, during armed state it draws approximately 250mA, and
during discharge draws between 0.3A-3.3A. Use only the pro-
vided DC power supply with the ChipSHOUTER, which has a
rating of 19V/3.42A.
Oscilloscope Probe Connectors
Both the voltage and current output of the ChipSHOUTER can
be monitored via two probe connections on the top side of
the device. Adapter cables are included for connecting to an
oscilloscope, use only these matching NewAE cables for this
purpose. The external portions of these two probes are iden-
tical and can be plugged in to either socket. These are
described in more detail on page 39 in the section Oscillo-
scope Pulse Shape Monitoring.
To Next Page
Loading...