iv
XY(Z) Table Connection ........................................ 62
Troubleshooting ............................................... 63
Table of Figures
Figure 1: Overview of ChipSHOUTER device architecture. ........ 15
Figure 2: 4mm tip pulse width ................................. 20
Figure 3: 1mm tip pulse width ................................. 21
Figure 4: External connectors on the ChipSHOUTER. ............. 22
Figure 5: RJ12 Connector on ChipSHOUTER Panel. ................ 25
Figure 6: CW322 Simple Target ................................. 30
Figure 7: CW522 Ballistic Gel ................................. 33
Figure 8: Detail of the 4MM/CCW tip construction. ............. 36
Figure 9: Detail of included probes. .......................... 37
Figure 8: Inserted pulse viewed on oscilloscope screen. ....... 39
Figure 11: Tuning oscilloscope probe. ......................... 41
Figure 10: Example calibration waveform. ...................... 42
Figure 11: Removing blanking plug. ............................ 44
Figure 14: Adding air inlet adapter. .......................... 44
Figure 15: USB Interface for ChipSHOUTER ...................... 59
• Fix RJ12 pinout, small clarifica-
tions throughout, add more detail of
external hardware trigger, add more
detail of probe construction.
• Initial release, minor fixes.
• Add troubleshooting section.
To Next Page
Loading...