Newport LDC-3706 Series - Page 68

December 2019 56 LDC-3706 Series Laser Controller
NAME FUNCTION INSTrument
CALCulate:TRANsform:TEMPerature:SHHart:B?
Report coefficient B in Steinhart-
Hart resistance to temperature
equation for thermistors.
TEC
CALCulate:TRANsform:TEMPerature:SHHart:C <nrf>
Set coefficient B in Steinhart-Hart
resistance to temperature equation
for thermistors.
TEC
CALCulate:TRANsform:TEMPerature:SHHart:C?
Report coefficient B in Steinhart-
Hart resistance to temperature
equation for thermistors.
TEC
CALibrate:CUR100UA:STARt
Initiate calibration of 100 µA
thermistor current source.
TEC
CALibrate:CUR100UA:DATA <nrf>
Send measured current to 100 µA
calibration procedure.
TEC
CALibrate:CUR10UA:STARt
Initiate calibration of 10 µA
thermistor current source.
TEC
CALibrate:CUR10UA:DATA <nrf>
Send measured current to 10 µA
calibration procedure.
TEC
CALibrate:CURRent:STARt
Initiate calibration of current
procedure.
LAS, TEC
CALibrate:CURRent:DATA <nrf>
Sends measured current data to
current calibration procedure.
LAS, TEC
CALibrate:DATE <nrf>, <nrf>, <nrf>
Update calibration date of
instrument (LAS/TEC). Parameters
are month, date, year.
LAS, TEC
CALibrate:DATE?
Report calibration date of
instrument.
LAS, TEC
CALibrate:MDI:STARt
Initiate photodiode current
measurement calibration.
LAS
CALibrate:MDI:DATA <nrf>
Send measured photocurrent to MDI
calibration procedure.
LAS
CALibrate:PDI:STARt
Initiate photodiode current
measurement calibration. This is
the same procedure as
CALibrate:MDI:STARt
LAS
CALibrate:PDI:DATA <nrf>
Send measured photocurrent to PDI
calibration procedure.
LAS
CALibrate:RTD1000UA:STARt Initiate 1 mA RTD calibration. TEC
CALibrate:RTD1000UA:DATA <nrf>
Send measured RTD resistance to 1
mA RTD calibration procedure.
TEC
CALibrate:RTD2500UA:STARt Initiate 2.5 mA RTD calibration. TEC
CALibrate:RTD2500UA:DATA <nrf>
Send measured RTD resistance to 2.5
mA RTD calibration procedure.
TEC
CALibrate:SENSORI:STARt
Execute ICI sensor current
calibration procedure.
TEC
CALibrate:SENSORV:STARt
Perform ICV sensor voltage
measurement calibration.
TEC
CALibrate:SENSORV:DATA <nrf>
Send measured ICV sensor voltage to
sensor voltage calibration
procedure.
TEC