Newport LDC-3706 Series - Page 69

December 2019 57 LDC-3706 Series Laser Controller
NAME FUNCTION INSTrument
CALIbrate:VMEAS:STARt <nrf>
Initiate LDV or VTE measurement
calibration, based on which
instrument mode is currently
selected.
LAS, TEC
CALIbrate:VMEAS:DATA <nrf>
Send measured LDV or VTE voltage to
VMEAS calibration procedure.
LAS, TEC
DISPlay:BRIGhtness <nrf> Set display brightness. N/A
DISPlay:BRIGhtness? Report display brightness setting. N/A
DISPlay[:ENABle] <nrf> Turn display on or off. N/A
DISPlay[:ENABle]?
Reports display on or off
condition.
N/A
CONDition?
Report selected instrument’s
Condition status register.
LAS, TEC
ENABle:CONDition <nrf>
Set value of selected instrument’s
Condition Enable register.
LAS, TEC
ENABle:CONDition?
Report value of selected
instrument’s Condition Enable
register.
LAS, TEC
EVEnt?
Report selected instrument’s Event
status register.
LAS, TEC
ENABle:EVEnt <nrf>
Set value of selected instrument’s
Event Enable register.
LAS, TEC
ENABle:EVEnt?
Report value of selected
instrument’s Event Enable register.
LAS, TEC
FORMat:SREGister <string>
Set format of values sent to/read
from common registers ESE, ESR,
SRE, and STB.
N/A
FORMat:SREGister? Reports current format. N/A
INPut:BIAS:VOLTage <nrf> Set photodiode bias voltage. LAS
INPut:BIAS:VOLTage? Report photodiode bias voltage. LAS
INPut:FILTer:[LPASs]:[:STATe] <nrf>
Enable or disable laser current
low-pass filter.
LAS
INPut:FILTer:[LPASs]:[:STATe]? Report state of low-pass filter. LAS
INSTrument:CATalog?
Reports the possible instrument
type settings available.
N/A
INSTrument:NSELect <nrf>
Selects between Laser current
source or TE controller instrument
operating modes.
N/A
INSTrument:NSELect?
Reports currently selected
instrument operating mode.
N/A
INSTrument[:SELect] <string>
Selects between Laser current
source or TE controller instrument
operating modes.
N/A
INSTrument[:SELect]?
Reports currently selected
instrument operating mode.
N/A