Newport LDC-3706 Series - Page 83

December 2019 71 LDC-3706 Series Laser Controller
CALibrate:CURR10UA:STARt TEC
Description Begins the 10 µA thermistor calibration procedure.
CALibrate:CURR10UA:DATA <nrf> TEC
Description Send data point for the 10 µA thermistor calibration procedure.
Parameters DATA – a number representing the actual current in Amps
Example CAL:CURR100UA:DATA 0.001; Sends a data point of 0.001A.
CALibrate:CURRent:STARt LAS TEC
Description Begins the laser current calibration procedure if the laser diode mode is selected or for the TEC current output
calibration procedure if the TEC controller mode is selected (see the INSTrument[:SELect] command).
CALibrate:CURRent:DATA <nrf> LAS TEC
Description Send data point for the laser current calibration procedure if the laser diode mode is selected or for the TEC
current output calibration procedure if the TEC controller mode is selected (see the INSTrument[:SELect]
command).
Parameters DATA – a number representing the actual current in Amps
Example CAL:CURR:DATA 0.5; Sends a data point of 0.5A.
CALibrate:DATE <nrf>,<nrf>,<nrf> LAS TEC
CALibrate:DATE?
Description Sets/Reports the calibration date information for the instrument.
Parameters Month, Day, Year – the month, day, and year that represent the last calibration date
Example CAL:DATE 05,13,2016; Sets the calibration date to May 13, 2016.
CALibrate:MDI:STARt LAS
Description Begins the monitor photodiode current calibration procedure.
CALibrate:MDI:DATA <nrf> LAS
Description Send data point for the monitor photodiode current calibration procedure.
Parameters DATA – a number representing the actual current in Amps
Notes This is the same as CALibrate:PDI:STARt and CALibrate:PDI[:DATA] below; there are two versions for user
flexibility
Example CAL:MDI:DATA 0.0005; Sends a data point of 0.0005A.