December 2019 73 LDC-3706 Series Laser Controller
CALibrate:SENSORV:DATA <nrf> TEC
Description Send data point for the TE ICV sensor voltage calibration procedure.
Parameters DATA – a number representing the actual voltage in Volts
Example CAL:SENSORV:DATA 1.7; Sends a data point of 1.7V.
CALibrate:VMEAS:STARt LAS TEC
Description Begins the laser voltage calibration procedure if the laser diode mode is selected or for the TEC voltage
calibration procedure if the TEC controller mode is selected (see the INSTrument[:SELect] command).
CALibrate:VMEAS:DATA <nrf> LAS TEC
Description Send data point for the laser voltage calibration procedure if the laser diode mode is selected or for the TEC
voltage calibration procedure if the TEC controller mode is selected (see the INSTrument[:SELect] command).
Parameters DATA – a number representing the actual voltage in Volts
Example CAL:VMEAS:DATA 1.7; Sends a data point of 1.7V.
DISPlay:BRIGhtness <nrf> N/A
DISPlay:BRIGhtness?
Description Sets/Reports brightness setting of the front panel displays.
Parameters 0 – 10 – The level of brightness desired
(1 = minimum brightness, 10 = full brightness)
Reset Value 5.12
Example DISP:BRIG 5; Changes the brightness to 5.
DISPlay[:ENABle] <nrf> N/A
DISPlay[:ENABle]?
Description Sets/Reports on/off state of the front panel displays.
Parameters 0 or 1 – 0 for off, 1 for on
Reset Value 1
Example DISP 1; Turns the display on.
To Next Page
Loading...
