December 2019 75 LDC-3706 Series Laser Controller
ENABle:CONDition <nrf>
LAS TEC
ENABle:CONDition?
Description Sets or reports the selected instrument’s Condition Enable status register. See chapter 3, Status Reporting.
See CONDition? Command for bit table.
Parameter A number containing the bit-encoded value to set in the register.
Example ENAB:COND 16
Only bit 4 is set; when an interlock error occurs the Laser Condition Summary bit will be set in the Status Byte.
EVEnt?
LAS TEC
Description Reports the selected instrument’s Event status register. See chapter 3, Status Reporting. This query will report
the event status register, then clear the register.
Example EVE?
A response of 8 (bit 3 set) indicates that a Over High T or R Limit condition occurred since the last read of the
Event register.
To Next Page
Loading...
