Newport LDC-3706 Series - Page 88

December 2019 76 LDC-3706 Series Laser Controller
ENABle:EVEnt <nrf> LAS TEC
ENABle:EVEnt?
Description Sets or reports the selected instrument’s Event Enable status register. See chapter 3, Status Reporting.
See EVEnt? Command for bit table.
Parameter A number containing the bit-encoded value to set in the register.
Example ENAB:EVE 2
Bit 1 is set, so a voltage-limit event will cause the Laser Event Summary bit to be set in the Status Byte.
FORMat:SREGister <string> N/A
FORMat:SREGister?
Description Sets or reports the output format for NR1 types.
Parameter Valid Parameter input strings: Report output format:
ASCii 0 (numeric)
HEXadecimal 1 (hexadecimal)
OCTal 2 (octal)
BINary 3 (binary)
Reset Value ASCii
Example FORMat:SREGister OCT; Changes the output format to Octal.
INPut:BIAS:VOLTage <nrf> LAS
INPut:BIAS:VOLTage?
Description Sets/Reports photodiode bias voltage value.
Parameters 0.000 – 5.000 – The desired PD bias voltage in Volts.
Reset Value 0.0
Example INP:BIAS:VOLT 2.5; Sets the photodiode bias voltage to 2.5V.
INPut:FILTer:[LPASs][:STATe] <bool> LAS
INPut:FILTer:[LPASs][:STATe]?
Description Enables/Reports state of laser current filter.
Parameters 0 or 1 – 0 for disable low pass filer, 1 for enable low pass filter.
Reset Value 0
Example INP:FILT 0; Sets the laser current filter to low pass.
INSTrument:CATalog? N/A
Description Reports the possible instrument mode selections for the LDC-3706.
Response Responds with the string “LAS, TEC”, the two possible operating modes for the LDC-3706.