Newport New Focus Picomotor 8742 - Page 83

Remote Command Set 83
SD?
Description Scan done status query.
Syntax SD?
Remarks This command is used to query the scan status.
Response Value Description
Value 0 Scan is in progress
1 Scan is not in progress
Example
SD? (Get scan status)
1 (Returns value of 1 which means scan is not in progress)
See Also
SC, SC?
SM
Description Save settings command
Syntax SM
Remarks This command saves the controller settings in its non-volatile memory. The controller
restores or reloads these settings to working registers automatically after system reset or
it reboots. The Purge (XX) command is used to clear non-volatile memory and restore to
factory settings. Note that the SM saves parameters for all motors.
The SM command saves the following settings:
1. Hostname (see HOSTNAME command)
2. IP Mode (see IPMODE command)
3. IP Address (see IPADDRESS command)
4. Subnet mask address (see NETMASK command)
5. Gateway address (see GATEWAY command)
6. Configuration register (see ZZ command)
7. Motor type (see QM command)
8. Desired Velocity (see VA command)
9. Desired Acceleration (see AC command)
Example 1VA 1750; 2VA1500 (See motor 1 & 2 velocity)
SM (Save settings to non-volatile memory)
See Also XX, *RCL