94 Remote Command Set
Description IP mode set command.
Syntax IPMODEnn
Remarks This command is used to set the controller’s IP mode. In order for this setting to take
effect, please save this setting in the controller’s non-volatile memory and reset the
controller.
As the name implies, Static IP addresses are the same every time you connect.
Dynamic IP addresses may change each time you connect to the Internet. Dynamic IP
addresses are the normal customer access method used by most ISPs or Service Providers
and this is the default IP mode for this product
Having a static IP address for your dedicated server means an IP address will be assigned
to your server (controller) only once and that IP address will belong to your dedicated
server forever. A static IP address will be given out to your dedicated server so that every
time it logs in it will be using the same IP address for all of its sessions.
NOTE: Send this command via USB interface as Ethernet communication may
become unstable during Ethernet settings configuration. While connected via USB,
use the Picomotor application software to send commands (Go to ‘Terminal’ tab).
Argument Value Description
nn 0 Static IP
1 DHCP (default)
Example:
IPMODE 0 (Set to static IP mode)
GATEWAY
192.168.10.101 (Set gateway address)
NETMASK 255.255.255.0 (Set Netmask address)
IPADDR 192.168.1.101 (Set IP address)
SM; RS (Save and reset system)
See Also IPMODE?, IPADDR, SM, RS
To Next Page
Loading...
