Newport New Focus Picomotor 8742 - Page 95

Remote Command Set 95
IPMODE?
Description IP mode query.
Syntax IPMODE?
Remarks This command is used to query the controller’s IP mode.
Response Value Description
nn Integer IP mode
Example: IPMODE ? (Get IP mode)
1 (Returns 1; in DHCP mode)
See Also IPMODE
MACADDR?
Description MAC address query.
Syntax MACADDR?
Remarks This command is used to query the controller’s MAC address.
A Media Access Control address (MAC address) is a unique identifier assigned
to network interfaces for communications on the physical network segment. MAC
addresses are used for numerous network technologies and most IEEE 802 network
technologies, including Ethernet. Logically, MAC addresses are used in the Media
Access Control protocol sub-layer of the OSI reference model.
Response Value Description
address nn1,nn2 MAC address. (Example.5827809, 20)
nn1 is Newport’s unique identifier (0x58ECE1);
nn2 is controller’s unique identifier
Example:
MACADDR ? (Get MAC address)
5827809, 20 (Returns 5827809, 20; MAC address)
See Also
HOSTNAME